STEINEL HF 3600 Manual descargar pdf (Pagina 7)

12 13

If in doubt, the cables must

be identiﬁ ed with a voltage

tester; subsequently switch

off the current again.

The phase (L) and neutral

conductor (N) are connect-

ed according to terminal

assignment. The protect-

ive-earth conductor is con-

nect

ed to the earth terminal

( ). A mains switch for

on and off switching can of

course be installed in the

mains lead. This is a pre-

requisite for the permanent

light function (refer to Func-

tions section).

b) Connection of the

consumer lead

The consumer lead to the

light also consists of a 2

to 3-lead cable. The phase

conductor of the light is

installed in the terminal

marked L’. The neutral

conductor is connected

with the neutral lead of

the mains lead to the

terminal marked N. The

protective-earth conductor

is connected to the earth

terminal.

Important: Reversing the

connections may result in

damage to the unit.

7. Close the housing again.

8. Perform twilight setting

, time  and reach 

setting (refer to Functions

section).

9. Apply design cover 

and secure with the safety

screw  against unauthor-

ised removal.

Angle of coverage: 360°

8 m

max.

The HF 3600 is an active

motion detector and reacts

– depending on tempera-

ture – to the slightest move-

ments. The integrated

Principle

HF sensor emits high-

frequency electromag-

netic waves (5.8 GHz) and

receives their echo. In

response to the slightest

movement in the detec-

tion zone, the change in

echo is perceived by the

sensor. A microproces-

sor subsequently triggers

almost without delay the

switching command “light

on“. Detection is possible

through doors, panes of

glass or thin walls.



Disconnect the power

supply before any work

on the sensor!



During installation, the

electric power cable to

be connected must be

voltage-free. Therefore,

switch off the power ﬁ rst

and check freedom from

voltage with a voltage

tester.



Installation of the sen-

sor involves work on the

mains power supply; it

must therefore be per-

formed correctly accord-

ing to the conventional

installation regulations

and connection condi-

tions.



Please note that the sen-

sor must be protected

by a 10 A circuit breaker.



The mains supply lead

must be no greater than

10 mm in diameter.

Safety instructions

Installation procedure:

1. Remove design cover

. 2. Fold up installation

housing .

3. Mark drilling holes.

4. Drill holes and insert

dowels (6 mm).

5. Pierce wall for cable runs

as required for surface-

mounted or ﬂ ush cabling

and screw on housing.

Installation/wall installation

6. Feed through cable of

the mains and consumer

lead and connect. Use

sealing plugs for surface-

mounted cabling.

a) Connection of the

mains lead

The mains lead consists of

a 2 to 3-lead cable:

L = phase

N = neutral conductor

PE = protective-earth

conductor

Surface-mounted cabling

with wall mount

Note: The inside wall mount

can also be used for wall

installation. The cables can

therefore be fed conveni-

ently from above behind

the device and through the

opening of the surface-

mounted cabling.

Flush-ﬁ tted

installation

Surface-mounted

installation

Ø 6 mm

Mains lead

Consumer lead

1 2 3 4 5 6 7 8 9 10 11 12 ... 57 58

Comentarios a estos manuales

Sin comentarios